Part # 438031987 - 2001 Jeep Cherokee 4x4 Sport3.5” EZ-Flex Suspension System with rear springsPart# DescriptionQty.XJ3F-CL01 Front coil spring 2TJ3A-
37. Locate the new rear springs. Remove the bushings andsleeves from the new springs and add some lithium or molybase grease to the bushings and sleev
Working on the driver side, install the new shock into the OE location using the OE hardware. Make sure to use loctiteand torque to lower hardware to
Limited lifetime warranty Notice to all Tuff Country EZ-Ride Suspensioncustomers: It is your responsibility to keep youroriginal sales receipt! If fai
Special note: Before installation begins, it is thecustomers/installers responsibility to make sure that allparts are on hand. If any parts are missin
3. Working on the driver side, remove the sway bar endlinkfrom the sway bar and axle location. Save the hardware andendlink. Repeat procedure on the p
7. Working on the driver side, remove the coil spring clipfrom the axle. Save the clip and hardware. Repeat proce-dure on the passenger side.8. Carefu
11. Locate the new EZ-Flex control arms. Set each controlarm to 16 1/2” from the center of eye to the center of eye. 12. Working on the driver side, i
15. Make sure that newly installed track bar bracket is seat-ing flush in the OE pocket. Using the new bracket as a guide,carefully drill a 3/8” hole
22. Working on the driver side, install the OE sway barendlink back to the OE location using the OE hardware.Repeat procedure on the passenger side. 2
30. Working on the driver side, add some loctite to the newlyinstalled transfer case spacer hardware and torque to 28 ftlbs. Repeat procedure on the p
Comments to this Manuals