Part # 540702007 - 2013 Toyota Tundra 4WD & 2WD4” Suspension SystemPart# DescriptionQty.54070-01 DS & PS Upper strut spacer 254070-02 Driver S
30. Locate the new sway bar relocation brackets. Also,locate (4) 12 mm x 60 mm bolts, (4) 12 mm flat washers and(4) 12 mm lock washers from hardware b
40. Carefully lower down on both hydraulic floor jacks at thesame time allowing enough room for the rear blocks to beinstalled. Special note: Take sp
Special note: The OE shocks will NOT be long enough once this suspension system has been installed. If youhave not already ordered your rear shocks, p
54070-01 / Qty (2)DS & PS Upper Strut Spacer54070-02 / Qty (1)Driver Side Upper Control Arm54070-03 / Qty (1)Passenger Side Upper Control Arm54070
Limited lifetime warranty Notice to all Tuff Country EZ-Ride Suspensioncustomers: It is your responsibility to keep youroriginal sales receipt! If fai
Hardware bag 54070NB includes:DescriptionQuantityS10051 (1.750” x .510” x .950” sleeve) 2S10077 (oversize washer) 4S10239 (.750” x .625” x 2.348” slee
4. Locate (2) S10051 sleeves from hardware bag 54070NB..Also, locate (2) 1/2” x 6” bolts, (2) 7/16” USS flat washersand (2) 1/2” unitorque nuts from h
11. Working on the driver side, loosen but do not remove thecastle nut holding the upper control arm to the knuckle. Witha hammer, hit the knuckle to
16. Locate the new sert fittings from hardware bag54070NB1. Install the new sert fittings into the new uppercontrol arms. Special note: Make sure not
Tuff Country EZ-Ride Suspension recommends a wallmounted strut compressor be used when performingthe steps that talk about installing the pre-load spa
22. Locate the new upper strut spacer. Install the new upperstrut spacer to the modified coil over and secure using theOE hardware. Make sure to use l
26. Working on the driver side, move back to the upper strutspacer and add some loctite on the bolts holding the modi-fied strut into the upper locati
Comments to this Manuals