Part # 560702007 - 2008 Toyota Tundra6” suspension systemParts contained in Box 1 of 3Part# Description Qty.56070-03 Front cross member 156070-04 Rear
note: Take special care not to kink the hard line goingto the brake caliper. Repeat procedure on the passengerside.75. Working on the driver side, rem
This will help increase the life of the bushing and alsohelp prevent squeaking.83. Working on the driver side, remove the inner bolt thatconnects the
all the brake line and ABS points, make sure not to overextend or kink any brake lines or ABS lines.97. Working on the driver side and using a pair of
was removed earlier in the installation. Also, locate (1) 5/16”x 1” bolt, (2) 1/4” USS flat washers and (1) 5/16” unitorquenuts from hardware bag 5607
55070-01 / Qty. 1Driver side knuckle55070-02 / Qty. 1Passenger side knuckle56070-03 / Qty. 1Front cross member56070-06 / Qty. 1Rear lateral compressio
56070-13 / Qty. 1Front upper skid plate56070-14 / Qty. 4Driver and Passenger side frontbump stop relocation bracket56070-15 / Qty. 2Driver and Passeng
Limited lifetime warranty Notice to all Tuff Country EZ-Ride Suspensioncustomers: It is your responsibility to keep youroriginal sales receipt! If fai
Hardware bag 56070NB includes:Bag # 1Description Quantity516UN (5/16” unitorque nut) 1214WA (1/4” USS flat washer) 18SUW-916 (9/16 harden u-bolt washe
Please follow instructions carefully:Before installation begins, measure from the center ofthe hub, to the bottom of the fender well, and recordmeasur
16. Working on the driver side, remove the stock front andrear hardware that connects the stock lower control arminto the stock location. Set the stoc
cle towards the driver and also we want to make surethat we install the new 9/16” u-bolt harden washersbetween the stock front differential and the ne
41. Locate (1) BH01 breather hose and (1) BH02 breatherhose from hardware bag 56070NB1. Working on the driverside, remove the (2) stock breather hoses
the stock hardware. Set the stock upper strut bearing plateand isolator aside.50. Locate (1) new upper strut pre load spacer. Also, locatethe stock ha
62. Locate the stock (2) lower mounting bolts that connect-ed the stock knuckle to the stock lower control arm. Addsome thread locker or loctite to th
Comments to this Manuals