Part # 230002009 - 2013 Ford F150 3” suspension systemPart# DescriptionQty.23000-01 Driver side upper control arm 123000-02 Passenger side upper contr
36. Place a hydraulic floor jack under the driver and pas-senger side of the rear axle.37. Working on the driver side, remove and save the shockhardwa
installed u-bolts. Torque to 120 ft lbs. Repeat procedure onpassenger side.44. Working on the driver side, carefully re-install the ABSline clips to t
23000-01 / Qty (1)Driver side Upper Control Arm23000-02 / Qty (1)Pass. side Upper Control Arm23000-03 / Qty (1)Driver side Strut Spacer23000-04 / Qty
Limited lifetime warranty Notice to all Tuff Country EZ-Ride Suspensioncustomers: It is your responsibility to keep youroriginal sales receipt! If fai
Hardware bag 23000NB includes:DescriptionQuantityS10236 (.750” x .563” x 2.400” sleeve) 4PB69127 (poly bushing) 8SERT04 (sert fitting) 4Hardware bag 9
5. Working on the driver side, remove the outer tie rod fromthe OE knuckle. Save the hardware. Special note: Using ahammer and striking the knuckle wi
10. Working on the driver side, remove the upper control armfrom the upper control arm location. The upper control armmay be discarded but save the up
15. Install the modified bearing plate back to the strut usingthe OE hardware. Make sure to use loctite and torque to 55ft lbs. Special note: make sur
17. Repeat steps # 11 - 16 on the passenger side strut.18. Locate the new upper control arms. Locate (8) poly bush-ings and (4) sleeves from hardware
23. Working on the driver side, install the lower modified strutinto the lower control arm and secure using the OE hard-ware. Do not tighten at this
28. Working on the driver side, torque the castle nut holdingthe upper control arm to the knuckle to 70 ft lbs. Install thenew cotter pin to the ball
Comments to this Manuals