Part # 140592014 Chevy or GMC 1500 4WD4” suspension systemPart# DescriptionQty.14056-01 Upper strut spacer 214056-02 Rear upper shock bracket 214056-0
27. Locate (4) 10 mm x 55 mm bolts, (4) 10 mm unitorquenuts and (8) 10 mm flat washers from hardware bag14059NB. Working on the driver side, secure th
31. Working on the driver side, install the OE end link to thesway bar and lower control arm. Make sure to use loctite andhand tighten.32. Carefully r
41. Working on the driver side, remove the shock from theupper and lower location. Save the shock and hardware.Repeat procedure on the passenger side.
48. Working on the driver side, install the modified shock intothe upper and lower location using the OE hardware. Makesure to use loctite and torque
Limited lifetime warranty Notice to all Tuff Country EZ-Ride Suspensioncustomers: It is your responsibility to keep youroriginal sales receipt! If fai
Hardware bag 14059NB includes:DescriptionQuantity7165B (7/16” x 5” bolt) 438WA (3/8” USS flat washer) 8716UN (7/16” unitorque nut) 49163B (9/16” x 3”
5. Place a pair of hydraulic floor jacks under the front differ-ential. Carefully raise up on both hydraulic floor jacks at thesame time until they c
10. Using a die grinder, carefully notch out the OE crossmember following the lines that were scribed earlier. 11. Install the newly modified rear cro
16. Working on the driver side, remove the lower hardwaresecuring the strut to the lower control arm. The hardwaremay be discarded. Repeat procedure o
18. Working on the driver side, place a hydraulic floor jackunder the lower control arm. Repeat procedure on the pas-senger side.19. Working on the dr
21. Locate the new upper control arms. Locate (8) polybushings and (4) sleeves from hardware bag 14059PL.Install the new bushings and sleeves into the
24. Locate the OE struts and upper hardware. Install the OEnuts back to the upper studs of the strut. Using a die grinder,carefully cut off the nipple
Comments to this Manuals